Environmental due diligence in Alberta
Environmental Protection and Enhancement Act — Alta. Reg. 154/2009 (Remediation Regulation). Administered by Alberta Environment and Protected Areas. Closing instrument: Remediation Certificate (site-based or limited).
01The answer
Clean scope
$10,500–$41,400
50,000 sf reference asset
Critical path
24 days
Engagement to reviewed drafts
Cost index
0.95
1.00 = national reference
Schedule penalty
2 days
Applied to intrusive work
Environmental diligence in Alberta is a Alberta Environment and Protected Areas matter, not a municipal one. The Environmental Protection and Enhancement Act — specifically Alta. Reg. 154/2009 (Remediation Regulation) — sets what has to be investigated, who is competent to sign the report, and what has to be filed before a site is considered closed out. That is why cost and calendar move at the Alberta line and barely at all between Calgary and Edmonton: a consultant charges roughly the same to drill in either, but the filing route, the standards the lab reports against, and the regulator's review time are identical province-wide.
What forces intrusive work here is specific. Alberta imposes no automatic transactional trigger, so the driver is contractual: lender environmental policy, the Phase I APEC finding, and the buyer's need for a remediation certificate to cap liability on a former upstream or fuel-handling site. A buyer who reads that as discretionary tends to discover otherwise in the last week of the condition period, when the Phase I recommendation lands and the only remaining moves are an extension request or a waiver of the very condition that was protecting them.
The Envirolor reference scope for Alberta — a 50,000 sf industrial building, lender-financed, with no flagged site history — models at $10,500–$41,400 and a 24-day critical path from engagement to a reviewed set of drafts. Add a confirmed area of potential environmental concern and both numbers move sharply: the Phase II is the only report in the sequence that cannot start until the Phase I finishes, so it adds its full duration to the calendar rather than running alongside anything.
Regional pricing sits at an index of 0.95 against the national reference, which shows up mostly in drilling and lab logistics rather than in professional time. Envirolor applies a 2-day scheduling penalty to intrusive work in Alberta, reflecting the practical wait for utility locates, rig availability and lab turnaround rather than any regulatory delay.
Envirolor does not perform assessments and takes no fee from consultants. The figures on this page are modelled from published cost bands scaled by area, regional index and risk, so they are a budgeting and sequencing instrument, not a quotation. Where a promoted observation exists for a Alberta report type, it replaces the modelled band and is labelled as observed.
Envirolor facts
- Alberta governs contaminated sites under the Environmental Protection and Enhancement Act — Alta. Reg. 154/2009 (Remediation Regulation). The closing instrument is the remediation certificate (site-based or limited).
- On the Envirolor reference asset — a 50,000 sf lender-financed industrial building with no site-history flags — a clean scope in Alberta models at $10,500–$41,400 over a 24-day critical path.
- Envirolor tracks 14 Alberta markets against this jurisdiction's rules, with a regional cost index of 0.95 and a 2-day scheduling penalty on intrusive work.
How these figures were produced
- Modelled — Derived arithmetically from observed inputs using the published method; not a market quote.
- Baseline seed — A documented starting estimate awaiting first observation. Treat as an order-of-magnitude figure only.
02Cost bands
Report costs in Alberta
Modelled on a flagged 50,000 sf industrial asset with elevating devices, so every report in the catalogue appears. Your own asset will drop the ones it does not need.
| Report | Cost band | Days | Detail |
|---|---|---|---|
| Phase I Environmental Site Assessment | $2,100–$5,200 | 16 | Alberta detail |
| Phase II Environmental Site Assessment | $15,400–$83,400 | 32 | Alberta detail |
| Building Condition Assessment | $3,300–$13,300 | 19 | Alberta detail |
| Geotechnical Investigation | $7,600–$39,900 | 27 | Alberta detail |
| Roof and Building Envelope Review | $2,400–$10,500 | 13 | Alberta detail |
| Elevating Devices Condition Review | $1,700–$7,100 | 11 | Covered above |
| Designated Substance and Hazardous Materials Survey | $2,700–$12,400 | 15 | Alberta detail |
03Scope your own deal
Scope a Alberta deal
Enter the asset and the site history. The estimator decides which reports a lender and the Alberta regulator will actually require, prices each one, and sequences them into a calendar you can hold against your condition period.
Modelled cost
$10,500–$41,400
Midpoint $18,900
Critical path
24 days
Engagement to reviewed drafts
Risk screen
Low
No flag driving sampling
Condition period
21 days spare
Scope fits
| Report | Status | Cost band | Days | Lands |
|---|---|---|---|---|
| Roof / envelopeA 41-year-old roof is usually the largest single line in the reserve table; a dedicated review turns a range into a number. | Recommended | $2,400–$10,500 | 13 | Day 13 |
| DSS / hazmatA 1985 building is pre-ban construction: the survey is legally required before any renovation or demolition is tendered, and the abatement number belongs in the purchase price. | Required | $2,700–$12,400 | 15 | Day 15 |
| Phase I ESAEvery lender on a commercial file requires a Phase I addressed to it with reliance, dated within six months of funding. | Required | $2,100–$5,200 | 16 | Day 16 |
| BCA / PCAThe lender's reserve requirement is set off the BCA's capital table, so it is a funding condition, not a nice-to-have. | Required | $3,300–$13,300 | 19 | Day 19 |
Out of scope, and why
- Phase II ESA — No area of potential environmental concern was flagged, so the Phase I should close without sampling. If it does not, add roughly the Phase II band to both cost and calendar.
- Geotech — An existing building with a known grading history rarely needs a geotech at acquisition; add one before any addition.
- Elevator — No elevating devices in the asset.
Take this with you
Diligence scope memo
A scope of work you can send to a consultant, attach to a lender package, or hold against a condition-period calendar. Print to PDF — nothing leaves your browser.
- Prepared
- 2026-10-09 by Envirolor
- Jurisdiction
- Alberta — Alta. Reg. 154/2009 (Remediation Regulation)
- Asset
- 50,000 sf industrial, built 1985
- Site area
- 87,120 sf
- Risk screen
- Low (score 1)
- Condition period
- 45 calendar days
- Modelled cost
- $10,500–$41,400
- Critical path
- 24 calendar days
Scope of work
1. Roof and Building Envelope Review — Recommended
Roof-level inspection with core cuts where warranted, moisture scanning, flashing and parapet review, and an envelope assessment covering cladding, sealants and glazing, with remaining service life and replacement cost.
$2,400–$10,500 · engage day 0 · draft day 13
2. Designated Substance and Hazardous Materials Survey — Required
Bulk sampling and laboratory analysis for asbestos-containing materials, lead, mercury, silica and other designated substances, producing the inventory that must be handed to any contractor before demolition or renovation.
$2,700–$12,400 · engage day 0 · draft day 15
3. Phase I Environmental Site Assessment — Required
Records review (fire insurance plans, aerial photography, title, environmental registries), a site reconnaissance visit, and interviews with the owner, occupants and the municipality. The deliverable identifies areas of potential environmental concern (APECs) and states whether intrusive investigation is warranted.
$2,100–$5,200 · engage day 0 · draft day 16
4. Building Condition Assessment — Required
A walk-through of structure, envelope, roofing, mechanical, electrical, vertical transportation, life safety and site works, followed by an immediate-repair list and a capital reserve table projecting replacement costs over the study period.
$3,300–$13,300 · engage day 0 · draft day 19
Verdict
This scope runs 3 required and 1 discretionary report, for a modelled $10,500–$41,400 and a 24-day critical path from engagement to a reviewed set of drafts.
Against the 45-day condition period entered, that leaves 21 days of slack — enough to absorb one lab delay, not two.
No area of potential environmental concern was flagged, so the base case is a Phase I that closes clean. If it does not, the Phase II adds roughly 30 days and the sampling band to this answer.
Modelled figures produced by the Envirolor scoping method from published cost bands and the Environmental Protection and Enhancement Act (Alta. Reg. 154/2009 (Remediation Regulation)). Not a quotation and not professional advice. Confirm scope and fees with a qualified consultant before relying on this memo.
04Markets
14 Alberta markets tracked
05Questions
What triggers a Phase II ESA in Alberta?
Alberta imposes no automatic transactional trigger, so the driver is contractual: lender environmental policy, the Phase I APEC finding, and the buyer's need for a remediation certificate to cap liability on a former upstream or fuel-handling site.
What does a Phase I ESA cost in Alberta?
On a 50,000 sf commercial building, Envirolor models a Alberta Phase I at $2,100–$5,200, with a 16-day turnaround from engagement to draft. Records requests, not fieldwork, set that clock.
How long should a condition period be for Alberta diligence?
A clean scope on the reference asset needs 24 calendar days. If the Phase I is likely to recommend sampling, plan on the Phase II adding its full duration on top, because it cannot begin until the Phase I finding exists.
Who reviews the file in Alberta?
Alberta Environment and Protected Areas. The closing instrument is the remediation certificate (site-based or limited), and the consultant signing the report must meet the qualification the Environmental Protection and Enhancement Act sets.
06Sources
Sources
- [1] Environmental Protection and Enhancement Act — Alta. Reg. 154/2009 (Remediation Regulation) — Administered by Alberta Environment and Protected Areas.
- [2] CSA Z768-01, Phase I Environmental Site Assessment — Report standard.
Envirolor Data Desk method · Last updated 2026-08-15 · Maintained by Envirolor Data Desk
Scope: Alberta — 14 tracked markets, 6 published report pages
Inputs: Environmental Protection and Enhancement Act; Envirolor modelled cost bands
Next scheduled review: 2026-11-15
Not advice — Envirolor is a data publisher. We do not perform, certify, or supervise professional work, and nothing here is a quote, an engagement, or professional advice. Figures are indicative benchmarks for comparison and must be confirmed with a qualified professional before you rely on them. About Envirolor